All guides

Inning Pilot · Cameras

End a Mevo session and restore its settings

Use the restore controls when Pilot changed a Mevo’s SRT settings for a session.

General guidance · Check the controls available in your installed app.

Use in Pilot only for an available camera

In Devices, confirm the Mevo is available. If it is already in use, disconnect it from the other controller before retrying. If the device needs SRT, tap Reconnect and review the setup prompt. Confirm a moving preview. Changing Resolution or Max bitrate under SRT output can briefly restart the camera feed, so do that before going live or recording.

Stop outputs and use End Session

After the event, use Stop broadcast and the REC control as applicable. Wait for any recording to finish finalizing. If Pilot shows End Session, tap it and confirm End session and restore cameras. This ends previews and attempts to restore the Mevos Pilot changed. Keep the cameras powered and on the same network while it runs.

If restoration is pending

Open Devices and look for Mevo recovery. Read the status for the affected camera. Once it is reachable, tap Retry Restore. Keep Current Settings deliberately discards the pending restore and leaves the camera at its current settings. Use that option only when that is the intended outcome. If restoration still fails, record the camera name and exact status without resetting the camera.